WPT Installation Manual
Document No. 910-00005-01, Rev 17
Page 15 of 19
3.6
Checking Signal Strength
Each WPT attempts to find a primary and secondary wireless path back to the HUB.
The paths and associated signal strengths (1-5) from the WPT are displayed in the
“dt” menu.
NOTE: This menu is not available in Standalone mode.
•
Press the
▼
button and OVR button together for two seconds.
The display will show ‘dt’
•
Press the OVR button 5 times to see the primary path. °C icon is displayed,
indicating that the ID is being displayed (either a repeater ID or the HUB ID).
•
Press the OVR button again to see the wireless signal strength from the WPT to
the primary path.
•
Press the OVR button again to see the secondary path. °C icon is displayed,
indicating that the ID is being displayed (either a repeater ID or the HUB ID).
•
Press the OVR button again to see the wireless signal strength from the WPT to
the secondary path.
NOTE: The Set Point Icon will identify the path currently in use by WPT as shown in
Figure 17.
Figure 17. Primary and Secondary Path Signal Strengths
