SK-91467R-176PMC
FR Family MB91460 Series, Flash Programming, Doc. No. 002-05153 Rev. *A
55
ON
OFF
Dip-Switch S1
(programming mode)
1 2 3 4
MD3 MD2 MD1 MD0
Table 12-1: Jumper setting on starterkit SK-91467R-176PMC
Jumper
Setting
Description
JP81
1-2 closed
SIN0 is connected to RS232 transceiver
JP82
1-2 closed
SOT0 is connected to RS232 transceiver
JP86
1-2 closed
X2 Pin 4/6 is connected to RS232 transceiver
If your programming software needs connection of RTS and CTS or if it generates reset signal on RTS or DTR
line, refer to the following jumper list:
Table 12-2: Jumper settings for reset signal on starterkit SK-91467R-176PMC
Jumper
Setting
Description
JP88
closed
RTS and CTS is shortcut at connector X2
open
RTS and CTS is not shortcut at connector X2
JP87
1-2 closed
DTR can be used for system reset
2-3 closed
RTS can be used for system reset
JP80
closed
Reset will be done via UART0
JP51
1-2 closed
No polarity inversion for the DTR/RTS signal
2-3 closed
Polarity inversion for the DTR/RTS signal
JP53
Closed
External reset generation is active
MB91F467R needs a special mode pin setting for entering programming mode. Therefore set Dip Switch S1
(Mode Switch) for serial programming: (0,1,0,0) and press reset button before starting programming sequence:
Figure 12-2: Mode Pin setting for programming mode on SK-91467R-176PMC
