GALEP-Programmer
FR Family MB91460 Series, Flash Programming, Doc. No. 002-05153 Rev. *A
32
Figure 5-17. Serial Synchronous Programming
Connect the adapter to the Textool
TM
–socket (pins 5-44) and connect the adapter to the starterkit using flat
cable. Start the GALEP5 programmer software and use ‘Load’ command to load a bin or hex file. Select tab
‘Devices’ and browse to the correct device, e.g. MCU
Cypress
MB91F467D. Choose SYNC for serial
synchronous programming. In the information window below the correct programming adapter is listed. Use
‘Select Device!’ button to accept current selection.
Use the functions now enabled on the bottom of the window to select action:
Program: write loaded mhx/bin-file to MCU
Verify: compare loaded file to Flash contents
Blank: do a blank check
Read: read-out Flash content
Erase: perform a chip erase
After selecting a operation, tab ‘Action’ is automatically activated. Press ‘Start’ button to start operation.
For further information on available settings in software and jumper settings on starterkits have a look at
‘Options”
‘MB91F467D Options” (or other MCU type) and ‘Device Help’.
