SK-91463N-64PMC
FR Family MB91460 Series, Flash Programming, Doc. No. 002-05153 Rev. *A
52
ON
OFF
Dip-Switch S2
(programming mode)
1 2 3 4
MD0 MD1 MD2 MD3
Table 11-1: Jumper setting on starterkit SK-91463N-64PMC
Jumper
Setting
Description
JP6
closed
SIN0 of the MCU connected to UART B
JP8
closed
SOT0 of the MCU connected to UART B
If your programming software needs connection of RTS and CTS or if it generates reset signal on RTS or DTR
line, refer to the following jumper list:
Table 11-2: Jumper settings for reset signal on starterkit SK-91463N-64PMC
Jumper
Setting
Description
JP32
closed
RTS and CTS is shortcut at connector X5
open
RTS and CTS is not shortcut at connector X5
JP4
2-3 closed
UART B is used to generate reset
JP5
1-2 closed
DTR can be used for system reset
2-3 closed
RTS can be used for system reset
JP35
1-2 closed
No polarity inversion for the DTR/RTS signal
2-3 closed
Polarity inversion for the DTR/RTS signal
JP24
Closed
External reset generation is active
MB91F463N needs a special mode pin setting for entering programming mode. Therefore set Dip Switch S2
(Mode Switch) for serial programming: (0,0,1,0) and press reset button before starting programming sequence:
Figure 11-2: Mode Pin setting for programming mode on SK-91463N-64PMC
