CY4636 WirelessUSB™ LP Keyboard Mouse Reference Design Kit User Guide, Doc. # 001-70355 Rev. *A
23
Kit Operation
Figure 3-9. Programming Keyboard
Once
Programming Succeeded
appears in the Actions pane detach the MiniProg. A 2-pin jumper
installed from J3.1 to J2.1 enables the radio to power the processor.
The keyboard is powered using two AA batteries. To start using the keyboard place the batteries in
battery compartment and bind it with the bridge. To bind the keyboard with the bridge press the bind
button on the bridge; the bridge goes into Bind Mode. In Bind Mode, the red LED blinks ON/OFF.
The bridge uses the Bind ID to communicate with the keyboard to bind to the system and then press
the bind button on the keyboard.
Once the keyboard is bound with the bridge dongle, the keyboard works smoothly with the system.
The green LED turns on when the dongle receives data from keyboard. It remains on for 250 ms
after the last received data packet. The green LED turns on and remains on if a key is pressed and
held (because the keyboard sends Keep Alive packets).
