CY3215-DK PSoC 1 In-Circuit Emulator Development Kit Guide, Doc. # 001-66514 Rev. *B
18
Using ICE-Cube Connector
Before connecting the flex cable to the ICE-Cube, assemble the three pieces (pod, plastic mask, and
foot), as shown in
1. Select a foot. The foot should match the pinout of the PSoC 1 device used in the target circuit.
2. Next, select the mask that matches the desired foot.
3. Insert the mask into the bottom of the pod, aligning the chamfered corners of the mask to the
pin-1 triangle on the pod.
4. Insert the foot through the plastic mask. Use the alignment triangles to orient the foot to the pod.
5. Plug the pod into the MiniEval board via ZIF socket.
Figure 3-8. Assembled Pod with Flex Cable
6. Connect the other end of the flex cable to the ICE-Cube pod connector, as shown in
.
7. Start debugging the project, as explained in
Figure 3-9. Flex Pod Connected to ICE-Cube Pod
