CYP CH-331H-RX, Operation Manual

Page: 23 / 44

18
■ Copy EDID: When multiple Receivers are in multicast mode,
checking this check box on one indicates which of the
Receivers will provide its EDID to the multicast Transmitters.
Note: This option is only valid in multicast mode. Only one
Receiver within the multicast group should have this option
enabled at a time.
■ Video Loss Options: Use the drop down to set the length of
time to wait for a lost source to return before showing the Link
Lost screen. Available options are: 3, 5, 10, 20, 30, 60 seconds,
or Never Timeout. If the “Turn off screen” checkbox is checked,
the HDMI output will be completely disabled, including sync,
after the timeout time has passed.
■ Scaler Output Mode: Use the drop down list to select the
preferred output resolution for the scaler. Selecting one of
the specific resolutions will output all video at that resolution.
Selecting “Pass- Through” will output the source video at its
original resolution. Selecting “Native” will attempt to scale to
the detected native resolution of the display connected to the
HDMI output.
2) Serial over IP: This section provides controls for the Serial over IP
extension functionality, including enabling/disabling serial support
and setting the RS-232 data configuration.
■ Enable Serial over IP: Unchecking this checkbox will disable the
serial port on this unit.
■ Serial Settings: Set the desired baud rate, data bits, parity, and
stop bit for the RS-232 signal to extend.
Note: The Transmitter and Receiver must have the same serial
settings.