CYP CH-331H-RX, Operation Manual

Page: 16 / 44

11
1) Bezel and Gap Compensation: This section of the Video Wall tab
is used to define the physical dimensions of each display being
used in the video wall. Accurate measurements are needed of the
monitor’s outer frame (OW, OH) and the video screen (VW, VH).
The measurements may be made using any unit of measurement
(inches, mm, cm, etc.) as long as ALL measurements in the same
wall are made using the exact same units and the numbers are
integers.
Note: Typically all monitors in a video wall are identical and have
the same dimensions, but it is also possible to make a 2×2 wall
using differently sized displays as long as the same measurement
units are used to measure each display and the displays are still
arranged in a normal rectangular layout with all 4 corners meeting
at the same place.
■ OW (Outer Width): This is the horizontal measurement of the
display’s outer case (screen plus bezel).
■ OH (Outer Height): This is the vertical measurement of the
display’s outer case (screen plus bezel).
■ VW (Video Width): This is the horizontal measurement of the
display’s video screen.
■ VH (Video Height): This is the vertical measurement of the
display’s video screen.
■ Apply To: Select which unit(s) to send updated settings to when
“Apply” is pressed.
– Selecting “All” will send video wall bezel setting changes to
all units in the current video wall group.
– Selecting “This” will send video wall bezel setting changes to
the unit whose WebGUI you are currently connected to.
– Selecting an IP address from the “Clients” list will send any
bezel setting changes to the Receiver with that IP address.