CYP CH-331H-RX, Operation Manual

Page: 9 / 44

4
A C: Press this button momentarily to increase the
streaming channel to the next available channel on the local
network.
Note: If no other channels are detected, the channel number
will not change.
B MODE: Press this button momentarily to toggle the video data
streaming method between “Graphic” and “Video” modes.
“Graphic” mode is optimized for high-detail static displays and
“Video” mode is optimized for full motion video.
Note: Pressing and holding the MODE button while the unit is
powering on will perform a full factory reset on the unit. Once
the reset is complete, both LEDs will flash rapidly and the unit
must then be manually power cycled.
6.2 Rear Panel
DC 5V
LAN IN OUT
IR
RS-232 HDMI OUT
1 2 3 4 5 6
1
HDMI OUT Port: Connect to an HDMI TV, monitor, or amplifier for
digital video and audio output.
2 RS-232 Port: Connect to a PC, laptop, or serial controllable device
for the extension of RS-232 signals. The baud rate is configurable,
but the default baud rate is 115200.
Note: When a Transmitter is in multicast mode, every connected
Receiver unit can send RS-232 commands to that Transmitter
and commands sent from the Transmitter side will be sent to all
associated Receivers.
3
IR IN Port: Connect to an IR Extender to receive IR control signals
and extend them to devices connected to the Transmitter on the
same broadcast channel. Ensure that the remote being used is
within direct line-of-sight of the IR Extender.
4
IR OUT Port: Connect to the provided IR Blaster to transmit IR signals
from the Transmitter on the same broadcast channel to devices
within direct line-of-sight of the IR Blaster.