![background image](http://html1.mh-extra.com/html/cybex/autoview-commander/autoview-commander_installer-user-manual_2703651017.webp)
11
Keyboard
Switching
One of the ways to change the active channel in a non-secured AutoView
system is by entering a short sequence of keystrokes on the keyboard. This
is called keyboard, or hot-key, switching.
Note:
Hot-key switching is only available in the default non-secure state.
For more information on secure versus non-secure operation, see
the ‘Administrator Functions’ section of Chapter 4.
The first set of keystrokes places your system in Command Mode. As long
as you are operating in Command Mode, whatever you type will be
interpreted as channel switch commands until the Enter or the Escape key
is pressed to terminate Command Mode. None of the keystrokes entered
will be forwarded to the attached computer until you exit Command Mode.
Next, enter the address
(Addr)
for the channel you wish to select.
Press
Enter
to accept the new channel. The following command line
shows the proper format used to switch your active channel via keyboard.
Below is a sample of a keyboard switching session, with an accompanying
explanation for each step.
Key Sequence
Action
1. <CM>
E
<Enter>
Selects Channel E on the base unit as the active channel.
2. <CM>
CF
<Enter>
Selects the AutoView attached to channel C on the base
unit, then selects channel F on the cascaded unit.
3. <CM>
G
<Enter>
Selects Channel G on the base unit as the active channel.
4. <CM>
BA
<ESC>
Exit Command Mode. The instruction is not executed. Channel
G is still the active channel.
Key Sequence
Action
<CM>
Addr
<Enter>
Selects an active channel via keyboard.
Basic Operations