![background image](http://html1.mh-extra.com/html/cybex/autoview-commander/autoview-commander_installer-user-manual_2703651018.webp)
AutoView Commander Installer/User Guide
12
System Control &
Maintenance
Key Sequence
Action
<CM>
K
n
<Enter>
Sets the keyboard scan set where
n
is a scan set number 1-3.
<CM>
MR
<Enter>
If you hot-plug your mouse cable, you may experience a loss of
mouse signal. Use this command to restore the signal if you are
using a PC with a standard PS/2 mouse driver.
<CM>
MW
<Enter>
If you hot-plug your mouse cable, you may experience a loss of
mouse signal. Use this command to restore the signal if you are
using a PC with a Microsoft IntelliMouse driver.
<CM>
AV
<Enter>
Displays the current firmware version of the processors inside
your AutoView unit. You
must
be either at a DOS prompt or in a
text editor/word processor to view this information.
<CM>
H1
<Enter>
Changes the hot-key sequence to the default:
1. Press and hold down the ‘Num Lock’ key.
2. Press and release the minus (-) key on the numeric keypad.
3. Release the ‘Num Lock’ key.
<CM>
H2
<Enter>
Changes the hot-key sequence to the 1st alternate:
1. Press and hold down the ‘Num Lock’ key.
2. Press and release the asterisk (*) key on the numeric keypad.
3. Release the ‘Num Lock’ key.
<CM>
H3
<Enter>
Changes the hot-key sequence to the 2nd alternate:
1. Press and hold down the ‘Control’ key.
2. Press and release the tilde (~) key.
3. Release the ‘Control’ key.
<CM>
<CM>
<CM>
<CM>
<CM>ZM<Enter>
<Enter>
<Enter>
<Enter>
<Enter>
Use this command to resynchronize the mouse after a device or
computer hot-plug. Repeat, if necessary, until synchronization is
re-established.
Note: Using this command while the mouse is operating
correctly will cause the mouse to lose sync.
The following commands are used for system control and maintenance.
Enter the command sequences to perform the actions described in the
table below.