CYBEX Arc Trainer 600A, Owner'S Service Manual

Page: 70 / 107

Cybex Arc Trainer Owner’s & Service Manual
Page 7-14
5. Remove the left crank cover.
A. Using a Phillips head screwdriver, remove the
three screws securing the left crank cover in
place. See Figure 6.
B. Remove the left crank cover.
! WARNING: Failure to release the drive belt
tension may cause personal injury
and may damage the unit.
6. Release the drive belt tension.
A. Using a 7/16” socket wrench, loosen the two
screws on the lower pivot shaft until the screws are raised 1/2” (1.25 cm) above the
shaft. See Figure 15.
NOTE: The drive belt tension is now released.
! WARNING: Do not touch components on the lower board. A charge can remain after
unplugging the power cord and turning off the unit.
7. Disconnect the brake cables.
A. Pull out on the lower board shield. See Figure 9. NOTE: It will snap out.
B. Locate the two brake cables on the lower board that are labeled J1 and J2.
C. Disconnect the two brake cables from the lower board.
! CAUTION: Pulley on eddy current brake is sharp. Wear work gloves to protect your hands.
8. Remove the eddy current brake.
A. Wear work gloves whenever handling the eddy current brake. The pulley is sharp. See
Figure 16.
Figure 16
Pins on
Brake
Mount
Bracket
Orientation of
the Cable
Secondary
Drive Belt
Flywheel
Figure 15
Loosen Screws
Lower Pivot
Shaft
Threaded Hole (4)
Screw (4)
Non-Threaded Hole (4)
Pulley
Screw (4)