CYBEX Arc Trainer 600A, Owner'S Service Manual

Page: 47 / 107

! CAUTION: A minimum of two people are required to lift, move and
assemble the unit. Always use proper lifting methods when
moving heavy items.
4. Lift and move the unit.
A. At least two people should lift and move or roll the unit to the location
where you intend to leave it. Use proper lifting methods.
5. Connect the display cable.
A. Remove the display cable from the
rubber band (discard rubber band).
B. Route the lower display cable through
one of the two gaskets. See Figure 3.
C. Place the gasket on top of the upright
tube but do not attach at this time.
D. Place the second gasket on top of the
other upright tube but do not attach at
this time.
E. Have a second person hold
the console over the upright
tubes and gaskets until step
6C. See Figure 4.
F. Connect the upper display
cable to the lower display
cable. See Figure 4.
6. Attach the handrail.
A. Ensure that the display cable
does not get pinched in step
6B.
B. Lower the console onto the
gaskets and continue to hold it
steady.
NOTE: Confirm that no
cables are pinched lowering the
console.
Cybex Arc Trainer Owner’s & Service Manual
Page 5-5
Table of Contents . . . . . . . . . iii
Service Schedule. . . . . . . . . 4-6
Warnings/Cautions . . . . . . . 5-1
Choosing & Preparing a Site 5-1
Electrical Power
Requirements . . . . . . . . . . 5-2
Assembling the Cybex
Arc Trainer . . . . . . . . . . . . . 5-2
Testing the Operation . . . . . . 5-9
Setting Operation Options. . 5-10
Figure 4
Lower Display
Cable
Upper Display
Cable
Figure 3
Gasket
Upright
Tube
Lower Display
Cable
Console
Assembly
3
2
1