Cybex 800S Stepper Owner’s Manual
• Time-Out: How long the stepper remembers workout information when someone stops
during a workout. You can set this to 30 seconds, one minute, or two minutes. You can
also choose to have no time-out; the stepper will remember the information until someone
starts a new workout.
• Always Prompt or Step and Go: If you choose "Step and Go," a user can get on the 800S
Stepper and start stepping, without entering any workout information. The default is
"Always Prompt."
When a user chooses "Step and Go" operation, the 800S Stepper uses the default
workout length (the one set as "First Workout Time") and default weight setting of 150
pounds (68kg).
• Announce Races: When someone else is starting a group race, should it be announced
on this stepper if the stepper isn't being used? Choose Yes or No. See Chapter 4 for
information on group races.
• Key Beep: Should the console keys beep when pressed? Choose Yes or No
3. When you're done setting options, press the Clear key twice to save your settings and
leave setup mode.
If you decide not to change the settings, turn the stepper off without leaving setup mode.
All settings keep their previous values.
Drive Cable Maintenance
With proper maintenance, your 800S Stepper will provide you with years of trouble-free
exercise. Routine maintenance is essential to not only preserve the life of the equipment, but
also to avoid any possibility of personal injury. Particular attention should be given to the
condition of the 800S Stepper drive cables. These cables will eventually wear out. We
recommend drive cables be inspected regularly for signs of wear and replaced every 6 to 8
months with Cybex-supplied replacement cables. Failure to perform drive cable maintenance
procedures could lead to cable damage and serious injury.
Page 2-7