Cybex 800S Stepper Owner’s Manual
Attaching the Display Upright to the Base
Attach the display cable on the bottom of the display upright (2) to the end of the display
cable on the base frame (1). Make sure the cable connector latches snap into place.
Attach the display upright (2) to the base frame
(1) using four 5/16" screws (14) and four 5/16"
lock was hers (15). Tighten all screws by hand
first, then tighten the screws labeled 14a with a
wrench, followed by the screws labeled 14b.
See Figure 2.
Installing the Display Upright Collar
Slide the display upright collar (4) down
over the display upright (2) and attach to
the base frame cover (1) using four #10
screws (16), as shown in Figure 3.
Attaching the Handrails to the Display Upright
Place the handrails (3) on the end of the display
upright (2), as shown in Figure 4. Make sure the
handrail bracket hooks over the tab on the end of
the display upright, and the display cable passes
through the handrail bracket. This keeps the
handrails in place until the you tighten the screws.
Install the four 5/16" screws (14) and four 5/16"
lock washers (15), tightening them all by hand.
Finish tightening the screws with a wrench,
tightening the screws labeled 14a first, then those
labeled 14b.
Page 2-3
2A
14
15
2
1
DETAIL 2A
14b
14b
14a
3A
4
2
1
DETAIL 3A
16
Figure 3 - Attaching the Display Upright Collar
Figure 2 - Attaching Display Upright
14c
15
3
2
14d
Figure 4 - Attaching the Handrails
