![background image](http://html.mh-extra.com/html/cybex/610a/610a_service-manual_2703484011.webp)
Cybex Arc Trainer 610A Service Manual
Service
Page 4-11
! CAUTION: Do not pinch your fingers between the belt and pulley during this procedure.
13. Attach the lower board assembly.
A.
Slide the lower board assembly over the two bottom screws and to the right.
B.
Using a Phillips head screwdriver, attach the top two screws and tighten the two bottom
screws securing the lower board assembly in place.
C.
Place the washer on the stud then follow it with the ground wire terminal. Use a 3/8”
nutdriver to secure the nut over the terminal. See Figure 10.
D.
Connect the elevation motor cable into the lower board.
E.
Place the shield into position and push in (the shield will snap in). See Figure 9.
14. Position the secondary drive belt.
A.
Slide the new secondary drive belt into place on the frame.
15. Secure the lower pivot assembly.
A.
Slide the lower pivot assembly through both drive belts and into place on the frame.
B.
Confirm that the secondary drive belt is straight and centered on the lower pulley. See
Figure 12.
C.
Confirm that the two spacers are still in place under the lower pivot shaft.
D.
Using a 7/16” socket wrench, tighten the two screws, two lock washers and two flat washers
securing the lower pivot assembly in place.
16. Check the tension of the primary drive belt.
A.
Press on the primary belt with your hand. You should not feel any “give” in the primary belt. If
the belt “gives”, follow step 17 through 18. Otherwise, skip to step 19.
NOTE:
The secondary
belt is self-tensioning.
17. Release the tension of the primary drive belt.
A.
Using a 1/2” socket wrench, loosen the bottom screw on the idler pulley. See Figure 14.
B.
Using a 1/2” socket wrench, loosen the top screw on the idler pulley See Figure 14.