![background image](http://html.mh-extra.com/html/cybex/610a/610a_service-manual_2703484020.webp)
Cybex Arc Trainer 610A Service Manual
Service
Page 4-20
Power Switch
Tools Required
• Phillips head screwdriver
1.
Disconnect the external power source.
A.
Turn the main power switch above the power inlet to the off (O) position.
B.
Unplug the power cord from the power outlet and from the power inlet.
2.
Remove the access cover.
A.
Using a Phillips head screwdriver, remove the four
screws securing the access cover. See Figure 2.
B.
Remove the access cover.
3.
Remove the power switch assembly.
A.
Using a Phillips head screwdriver, remove the two
screws on each side of the power switch. See
Figure 18.
B.
Reach inside the unit and pull the power switch
assembly up and out of the slot.
C.
Make note of which fast-ons are connected to the
connectors.
D.
Disconnect the three wires from the Filtered Power
Input Module (middle one).
E.
Connect the three wires (removed from step 5D) to the new Filtered Power Input Module See
Figure 4.
F.
Remove the three wires from power outlet module and remove this module from the old switch
plate.
G.
Place the existing power outlet module into the new switch plate.
H.
Connect the wires as shown in Figure 4.
I.
With two pieces of tape, mark the top two wires to the on/off switch.
NOTE:
The purpose for
marking the top two wires is so that you do not accidentally bypass the on/off switch when
reconnecting the wires.
J.
Remove the four wires from the on/off switch and remove the switch from the old switch plate.
K.
Place the existing on/off switch into the new switch plate (positioned exactly as removed from
the old switch plate).
L.
Connect the four wires as shown in Figure 4. Make sure the taped wires are connected to the
same connectors from step 5I. Remove the tape from the two wires.
Figure 18
Screw (2)