Setting Up the V2 Paging Server
Configuring the V2 Paging Server
CyberData Corporation
930367H
Operations Guide
22
2.4.6.1 Point-to-Point Configuration
When the board is set to not register with a SIP server, it's possible to set the device to dial out to a
single endpoint. To do this, do the following:
1. On the
SIP Configuration
page (
Figure 2-12
), make sure that the
Register with a SIP Server
parameter is not selected.
2. Type the IP address of the remote device that you want to contact into the
Dial out Extension
field
Note
The delayed DTMF functionality is available in the Point-to-Point Mode.
Note
Establishing point-to-point SiP calls may not work with all phones.
Figure 2-12. SIP Configuration Page Set to Point-to-Point Mode
Device is set to
NOT
register with a SIP server
