Setting Up the V2 Paging Server
Connecting the V2 Paging Server
CyberData Corporation
930367H
Operations Guide
9
2.3.5 Restore the Factory Default Settings
The V2 Paging Server is delivered with factory set default values for the parameters in
Table 2-3
. Use
the
RTFM
switch (see
Figure 2-7
) on the back of the unit to restore these parameters to the factory
default settings.
Figure 2-7. RTFM Switch
Note
When you perform this procedure, the factory default settings are restored. The default
parameters for access are shown in
Table 2-3
.
To restore these parameters to the factory default settings:
1. Press and hold the
RTFM
switch until the status and paging lights come on.
2. Continue to press the switch until after the indicator lights go off, and then release it.
3. The V2 Paging Server settings are restored to the factory defaults.
Table 2-3. Factory Default Settings
Parameter
Factory Default Setting
IP Addressing
DHCP
IP Address
a
a. Default if there is not a DHCP server present.
10.10.10.10
Web Access Username
admin
Web Access Password
admin
Subnet Mask
a
255.0.0.0
Default Gateway
a
10.0.0.1
RTFM Switch
