Setting Up the V2 Paging Server
Configuring the V2 Paging Server
CyberData Corporation
930367H
Operations Guide
14
4. On the
Home Page
, review the setup details and navigation buttons described in
Table 2-5
.
At this point you can:
• Review the V2 Paging Server’s
Current Settings
. Use the RTFM switch to restore the factory
default settings. See
2.3.5 "Restore the Factory Default Settings"
.
• Configure the network parameters. Click
Network Setup
and refer to
Section 2.4.5, "Configure
the Network Parameters"
for instructions.
• Configure the SIP parameters. Click
SIP Setup
and see
Section 2.4.6, "Configure the SiP
Parameters"
.
• Configure the PGROUPS parameters. Click
PGROUPS Setup
and see
Section 2.4.8, "Configure
the Paging Groups (PGROUPS) Parameters"
for instructions.
Note
Click the
Upgrade Firmware
button any time you need to upload new versions of the
firmware. Refer to
Section 2.5, "Upgrading the Firmware"
for instructions.
Table 2-5. Home Page Overview
Web Page Item
Description
Device Settings
Device Name
Shows the device name (25 character limit).
Change Username
Type in this field to change the username (25 character limit).
Change Password
Type in this field to change the password (19 character limit).
Re-enter Password
Type the password again in this field to confirm the new password
(19 character limit).
Current Settings
Serial Number
Shows the device serial number.
Mac Address
Shows the device Mac address.
Firmware Version
Shows the current firmware version.
IP Addressing
Shows the current IP addressing setting (
DHCP
or
Static
).
IP Address
Shows the current IP address.
Subnet Mask
Shows the current subnet mask address.
Default Gateway
Shows the current default gateway address.
DNS Server 1
Shows the current DNS Server 1 address.
DNS Server 2
Shows the current DNS Server 2 address.
SIP Mode is
Shows the current status of the SIP Mode.
Event Reporting is
Shows the current status of the Event Reporting.
Nightring is
Shows the current status of the Nightringer.
Click the
Save
button to save your configuration settings.
Note
: You need to reboot for changes to take effect.
Click on the
Reboot
button to reboot the system.
