CUSTOM TRUCK LOAD KING 25-92, Installation Manual

Page: 28 / 171

INSTALLATION
MAIN OUTRIGGER LEG INSTALLATION
5. Remove snap rings from outrigger pins.
Remove outrigger-link pins from links, as well
as outrigger pivot pin from mainframe. It may
be necessary to remove retaining zip ties by
cutting them. Discard zip ties. (plywood links
may also be used in this position, remove
and discard)
6. Uncap outrigger hoses on mainframe,
they contain hydraulic fluid, be sure to catch
this as they drain and protect the exposed
ends. Note that the hoses are marked with R
and E, for Retract and Extend.
7. Check pivot pin bores for paint
residue, this will need to be removed
before inserting the pins.
8. Using a single, wide lift strap, hoist
the outrigger leg into position, paying
attention to the orientation of the leg
and make sure it balances level.
Retract
Port
9. After removing the hydraulic caps
from the top of the cylinder, immediatly
connect the Extend and Retract hoses to
the proper ports on the outrigger cylin­
der. These ports should be marked with
a E and R, if these are not visible, the
port closest to the hydraulic piping on the
side of the cylinder is the retract port.
Hydraulic
Piping
Page 3 - 4
l
E
<ij
Extend
Port