Custom Audio Electronics KPM216HII-ETH, User Manual

Page: 89 / 112

The following fi gure shows a section of the device with the paper path and the distances (in mm) between the align-
ment sensor, the printing head and the cutter (cutting line).
Printing head Notch sensor
25.5
Autocutter
30
ESC/POS
TM
EMULATION
To de fi ne the alignment point you need to set the printer parameters that compose the numerical value of the “Notch
Distance” parameter. (see par.5.4).
For example, to set a notch distance of 15mm between the notch and the alignment point, the parameters must be
set on the following values:
Notch Distance Sign
: +
Notch Distance [mm x 10]
: 1
Notch Distance [mm x 1]
: 5
Notch Distance [mm x .1]
: 0
The “Notch Distance” parameter, may be modi fi ed as follows:
• during the Setup procedure of the device (see chapter 5)
• by modifying the Setup.ini fi le (see par.12.9)
• by using the $1D $E7 command (for more details, refer to the Commands Manual)
• by driver
10. ALIGNMENT
User manual
KPM216HII ETH 89