Custom Audio Electronics KPM216HII-ETH, User Manual

Page: 46 / 112

SHORT TICKET (<150mm)
This parameter allows the ticket management:
Disabled D = no check
Enabled = it is possible to manage tickets with length less than the distance
between the notch sensor and the printing line (160mm)
PRINT DENSITY
Adjusting the printing density:
-50% -12% +25%
-37% 0
D +37%
-25% +12% +50%
5.5 Ethernet parameters
This printer allows the con fi guration of the parameters listed in the following table.
The parameters marked with the symbol
D
are the default values.
Settings remain active even after the printer has been turned off.
DHCP CLIENT
Setting of the DHCP protocol:
Disabled D = protocol disabled
Enabled = protocol enabled
FTP SERVER
Setting of the FTP server:
Disabled D = server disabled
Enabled = server enabled
IP ADDRESS
IP address of printer; this parameter is assigned by the network administrator.
NOTE: Press the FORM FEED key to modify the value of the highlighted digit.
Pressing LINE FEED key to move the cursor on the next digit (if the cursor is on the latest digit, proceed
to next parameter by pressing the LINE FEED key).
SUBNET MASK
This parameter identifi es the local network address.
NOTE: Press the FORM FEED key to modify the value of the highlighted digit.
Pressing LINE FEED key to move the cursor on the next digit (if the cursor is on the latest digit, proceed
to next parameter by pressing the LINE FEED key).
DEFAULT GATEWAY
This parameter identifi es the Gateway IP address used to send applications to the ex-
ternal network.
NOTE: Press the FORM FEED key to modify the value of the highlighted digit.
Pressing LINE FEED key to move the cursor on the next digit (if the cursor is on the latest digit, proceed
to next parameter by pressing the LINE FEED key).
MAC ADDRESS
This is the number, provided by the constructor, that identifi es the printer; this number is
univocal.
NOTE: This parameter can’t be modi fi ed by set up.
ATTENTION:
Any changes to network parameters will interrupt browser connection. If the server not responding you
must reconnect to the new IP address set.
5. CONFIGURATION
46 KPM216HII ETH
User manual