Curtiss-Wright | PG Drives Technology
SK81935-01
70 | R-net Omni2 Technical Manual | Chapter 3 – Programming
Assume Position 1 = Seating and Position 1 Type = List, then the menu would appear as below.
Seating 1
>
Seating 2
>
The effect of List is to list all the available Profiles for the Mode. In this case the two Seating Profiles. The first line denotes the
lowest numbered Profile and the second line the next highest number Profile. In this case Seating Mode in Profile 1 and then
Profile 2. The text will be as set by the standard R-net parameter, Mode Name. Note, although it does in this case, the number
does not necessarily reflect the actual Profile number. Instead Seating 1 would actually enter the lowest numbered Profile
that had Seating Mode enabled, while Seating 2 would actually enter the next highest numbered Profile. A right SID command
will enter the highlighted Profile.
Assume Position 1 = Seating and Position 1 Type = Select, then the menu item would appear as below.
Seating
< 1 >
The effect of Select is to allow a new Profile to be selected, but not necessarily entered. Selection is via left and right SID
commands. There would be a further menu item, Seating, that would enter Seating Mode in the selected Profile.
2.11 PORTS 1 / 2 – BEEPS
2.11.1 PROFILE CHANGE
This sets the type of beep that occurs upon a Profile change.
The programmable options are: Off, Short and Long.
If set to Off, there will be no beep upon a Profile change.
If set to Short, there will be a short beep upon a Profile change.
If set to Long, there will be a long beep upon a Profile change.