14
13
16
CLEANING INSTRUCTIONS - CBFX
CI34
CFBX, CLEANING INSTRUCTIONS
082619J
15
Right
tube
Tee
Rear of
unit
Brush
13 Inspect the two plastic tubes that run
from the gear motors at the back of
the unit to the front for clogs.
14 Use the brush included with the unit
to clear any clogs that are found.
Remove the end of the tube from the
gear motor and insert the brush into
the end of the tube. Gently push the
brush in until it reaches the tee at the
front of the unit. When done, reinstall
the end of the tube and repeat the
procedure for the other tube, if
necessary.
15 Reinstall the panels.
Replace Seals/Reassemble
16 Using a pair of pliers, grasp the
outside of each drum bushing. While
rocking it back and forth, pull out on
the bushing, until it comes free from
the drum. Discard the bushings.
Preventive Maintenance (cont.)
17
Drum
front view
CORRECT
INCORRECT
Side Views of Drum
Drum
bushing
side view
Properly
seated bushing
O-ring
exposed
Drum
bushing
Line up teeth on drum bushing with
slots inside drum, top and bottom
NOTICE:
When installing the new
bushings, the teeth on the back of
each bushing must line up with the slots
inside the hole on the front of the drum.
When a bushing is not seated properly, one
of the O-rings on the bushing will be
exposed when viewed from the side.
17 Install the new bushings in place of the
old ones removed in step 16.
continued...
Left
tube
Disconnect
tube