![background image](http://html1.mh-extra.com/html/u-line/h-2274/h-2274_manual_3108838001.webp)
PAGE 1 OF 2
0721 IH-2274
1-800-295-5510
uline.com
AUTOMATIC PAPER
TOWEL DISPENSER
H-2274
MOUNTING
Mount dispenser securely on wall with supplied
hardware. Bottom edge should be approximately 52
inches above the floor.
OPENING THE COVER
Key is taped to back of dispenser.
1. Insert forked end of key into two slots at top of cover.
2. Push down on key and pull forward on cover.
Note: Opening the cover removes battery
power from control circuit.
LOADING BATTERIES
1. Open cover. Push left-hand tab on battery
compartment inward and lift up. (See Figure 1)
2. Insert four "D"-size alkaline batteries with "LR20"
designation. (Battery orientation is embossed on
compartment.
Note: We do not recommend using
rechargeable "D"-size batteries.
LOADING PAPER ROLL
1. Open cover and load paper roll with paper "tail"
unwinding from back of roll. Place paper "tail" under
transfer bar arm. (See Figure 2, A)
2. Close cover and move hand under unit to activate
dispense. Unit initially dispenses at factory-set
control settings. (See Figure 2, B)
LOADING STUB ROLL TRANSFER
To use this feature, the 3-inch or smaller stub roll must
be transferred from upper roll holders to stub roll holders
in rear, lower section. Stub roll paper monitor must be
positioned over stub roll paper "tail."
1. Insert new paper roll in upper roll holders. Place "tail"
of new paper roll on top of stub roll paper monitor
and under transfer bar arm. (See Figure 3, A-C)
2. Paper from new roll will automatically feed when
stub roll of paper runs out.
OPERATION
STUB-ROLL PAPER MONITOR
TRANSFER BAR ARM
BATTERY COMPARTMENT
B
A
A
B
C
Figure 1
Figure 3
Figure 2