PAGE 1 OF 6
0721 IH-1132
1-800-295-5510
uline.com
CENTER PULL TOWEL
DISPENSER
H-1132
NOTE: For both permanent and temporary
mounting, ensure that proper mounting
hardware is used for appropriate wall
composition. Enclosed hardware may not be
compatible with your wall surface.
PERMANENT MOUNTING
1. Place opened dispenser in intended mounting
position and mark location of three screw holes.
Recommended mounting height is 56" from floor to
bottom of dispenser. (See Figure 1)
2. Install top two screws halfway into wall.
Position dispenser on screws.
3. Install bottom screw through hole in dispenser
and tighten.
4. Finish tightening top two screws.
TEMPORARY OR PORTABLE MOUNTING
1. Place mounting bracket in position and mark
location of two screw holes. Recommended
mounting height is 65.5" from floor to top of bracket.
(See Figure 2)
2. Screw bracket to wall and mount dispenser.
NOTE: Temporary mounting may be made
permanent by installing third (bottom) screw
through hole in dispenser back.
MOUNTING INSTRUCTIONS
PARTS
Figure 2
Figure 1
Para Español, vea páginas 3-4.
Pour le français, consulter les pages 5-6.
Dispenser x 1
Mounting Bracket x 1
Mounting Bracket
65.5"
56"
Screw x 3
Wall Anchor x 3
Key x 1
TOOLS NEEDED
Drill
Drill Bit
Phillips Screwdriver
Level
Tape Measure
