27
OFF
A
B
C
Fig.33.
Fig.32.
ED. 0919 - 70702552 REV00 Leonardo - Use and maintenance
Warnings
Before carrying out any cleaning operation, it is neces-
sary to
disconnect the power supply
of the appliance
(acting on the system switch), wear adequate personal
protection equipment (e.g. gloves, etc.). The user must only car-
ry out routine maintenance operations, for any extraordinary
maintenance contact your Dealer requesting the intervention
of an authorized technician. Any damages deriving from lack of
maintenance or incorrect cleaning (e.g. use of unsuitable de-
tergents) are not covered by the Manufacturer’s warranty.
Any cleaning must be carried out with the oven
completely cold and wearing adequate personal
protection devices (e.g. gloves, etc.).
When cleaning any part or accessory do NOT use:
• abrasive or powder detergents;
• aggressive or corrosive detergents (e.g. hydrochloric/
muriatic or sulphuric acid, caustic soda, etc ...). Warning! Do
not use these substances even to clean the sub-structure/
floor under the appliance or base;
• abrasive or sharp tools (e.g. abrasive sponges, scrapers, steel
brushes, etc.);
• steamed or pressurised water jets.
It is best to have the Dealer perform maintenance and
inspect the appliance at least once a year to ensure top
working and safety conditions.
Keep the vents of the electrical compartment clean and clear.
Oven cleaning
Cleaning the external steel parts
Use a cloth dampened with hot soapy water and end with rins-
ing and drying.
Cleaning the refractory surface
Fig.32.
If the oven is used mainly with brick cooking, periodically
remove with a screwdriver the screws of the brick bead pro-
file, remove the refractory bricks from the front and suck the
charred residues on the bottom with an ash vacuum cleaner.
Before being repositioned, the refractory bricks can be cleaned
with a brush with stiff bristles.
Never use liquids to clean the refractory surface.
While reinserting the bricks, be careful not to pinch your
fingers.
Replacement refractory bricks can be obtained from the
Manufacturer on request.
Cleaning the rusticated surface
Fig.32.
With a screwdriver, remove the screws of the brick bead profile,
remove the rusticated surface from the front and clean it with
a soft cloth soaked in hot soapy water. Avoid using abrasive or
excessively aggressive products. Finish with a thorough rinsing
and drying, then reposition.
Cleaning the glass
Clean any glass with a soft cloth and special glass detergent.
Cleaning the display
Clean the display with a soft cloth and a little detergent for del-
icate surfaces. Avoid using large quantities of product as any
infiltrations might cause serious damage to the display. Avoid
using excessively aggressive detergents that may ruin the dis-
play construction material (polycarbonate).
Maintenance and cleaning
