3
6
CUES Inc.
,
PICS User Manual | CH915
www.cuesinc.com
,
SET-UP & INSTALLATION
ELECTRICAL & PHYSICAL CONNECTIONS -
To reduce the risk of equipment damage, please read the following instructions prior to operating the
system. Ensure that all of the equipment is turned to the OFF (O) position prior to connecting the PICS
system. Inspect all of the cables and connectors for cuts or worn areas prior to operating the equipment.
Repair or replace worn cables immediately.
PROCEDURE: Connecting the System
Power Source:
The PICS can be powered from the built-in, rechargeable battery, 110 AC mains power, or 12 VDC power.
If the internal battery is not going to be utilized, connect the unit to one of the external power sources
listed above.
Camera Centering Ball:
Ensure the centering ball, if needed, is attached to the mini camera as shown in this chapter.
Mini-Camera:
Ensure the mini-camera is connected and secured to the CX-1 cable end as shown in this chapter.
Adjustable Handle Height:
The PICS includes a height-adjustable handle for portability with cam locks and button stops. Refer to
the handle height adjustment instructions in this chapter.
Debris Bag:
An optional debris bag is provided to prevent debris from spilling/leaking out during and after the inspection.
Ensure the debris bag is attached to the PICS per the instructions in this chapter.
Adjustable Cable Guide:
Ensure the push cable is inserted through the cable guide for the most efficient
operation.
Accessory Bag:
An optional accessory bag is available to store additional items, as needed. Ensure the accessory bag is
attached to the PICS per the instructions in this chapter.
Monitor:
Ensure that the Control Unit cable is connected as shown in this chapter.
Power Control Unit (PCU):
The PICS system is controlled by the PCU (power control unit). The PCU contains all of the controls for
the system including system power, camera, lightring, recording, video titling, and observation coding.
Ensure that the PCU is connected as shown.
To adjust the Control Unit position, perform the following:
Swivel/rotate the PCU vertically and left-to-right to place the unit in differing viewing angles. Once the
desired position is determined, secure the unit by turning the hand knobs.