151
2. Direction of installation of dust seal and U
packing is as shown in the following drawing.
3. After tighten the packing case, calk the
packing case of both sides.
(2) HYDRAULIC CYLINDER ASSY
REINSTALLATION
*Install the hydraulic cylinder assy with reverse
procedure of removal. Use following values for
reinstallation as adjustment and service
standard.
1. Install the hose with red tape winded to lower
port.
Tightening torque of hose [18.08 lbf•ft]
4. Installation procedure of hydraulic cylinder
assy.
1) Set the length (B) of rod end (cylinder side)
to [1.693~1.772 in.]
2) Set the length (A) of rod end (knuckle side)
to [5.906 in.]
3) Adjust the toe-in by turning the rod L.H. and
R.H. equally. (See page 152)
4) Check the cylinder stroke and steering
angle.Cylinder stroke should be [8.898 in.]
and steering angle should be 48 ~ 50 .
Steering angle can be set by set bolt. Set
length of set bolt is [0.906 in.].
2. Turn the steering wheel to left and check the
tire is turning to left.
3. There is liner between chassis and front
bracket. (See page 14)
1) Tightening torque of front bracket
[61.48~68.71lbf•ft]
2) Tightening torque of chassis
[61.48~68.71lbf•ft]
2. Direction of installation of dust seal and U
packing is as shown in the following drawing.
3. After tighten the packing case, calk the
packing case of both sides.
(2) HYDRAULIC CYLINDER ASSY
REINSTALLATION
*Install the hydraulic cylinder assy with reverse
procedure of removal. Use following values for
reinstallation as adjustment and service
standard.
1. Install the hose with red tape winded to lower
port.
Tightening torque of hose [18.08 lbf•ft]
4. Installation procedure of hydraulic cylinder
assy.
1) Set the length (B) of rod end (cylinder side)
to [1.693~1.772 in.]
2) Set the length (A) of rod end (knuckle side)
to [5.906 in.]
3) Adjust the toe-in by turning the rod L.H. and
R.H. equally. (See page 152)
4) Check the cylinder stroke and steering
angle.Cylinder stroke should be [8.898 in.]
and steering angle should be 48 ~ 50 .
Steering angle can be set by set bolt. Set
length of set bolt is [0.906 in.].
2. Turn the steering wheel to left and check the
tire is turning to left.
3. There is liner between chassis and front
bracket. (See page 14)
1) Tightening torque of front bracket
[61.48~68.71lbf•ft]
2) Tightening torque of chassis
[61.48~68.71lbf•ft]
Summary of Contents for 7360SS
