28
Gateway(config-wlan1)# no
ldpc
Disble LDPC function.
Gateway(config-wlan1)# no
multicast-rate
Return multicast rate to default value
Gateway(config-wlan1)# no
multicast-to-unicast
Disable Multicast to Unicast function.
Gateway(config-wlan1)# no
protection
Disable Protection function.
Gateway(config-wlan1)# no
rf-output-power
Return RF output power to default value.
Gateway(config-wlan1)# no
rts-threshold
Return RTS threshold to default value.
Gateway(config-wlan1)# no
short-gi
Disable Short GI function.
Gateway(config-wlan1)# no
stbc
Disable STBC function.
Gateway(config-wlan1)# no
tdls channel-switch-
prohibited
Disable TDLS Channel Switch Prohibited
function.
Gateway(config-wlan1)# no
tdls prohibited
Disable TDLS Prohibited function.
Gateway(config-wlan1)# no
tx-breamforming
Disable Tx-Beamforming function.
Gateway(config-wlan1)# no
wlan-partition
Disable WLAN Partition function.
Gateway(config-wlan1)# no
wps
Disable WPS function
Show Command
Gateway(config)# show
interface wlan1
Shows the current advanced status of WiFi 5G.
For Bandwidth 2.4G:
Command
Parameter
Description
Gateway(config)# interface
wlan2
Access WiFi bandwidth 2.4G advanced
settings.
Gateway(config)# interface
wlan2 apply
Apply all change made on WiFi bandwidth
2.4G advanced settings.
Gateway(config-wlan2)#
aggregation
Enable Aggregation function.
Gateway(config-wlan2)#
beacon-interval [20-1024]
[20-1024]
Specify the Beacon Interval threshold in ms
ranging between 20-1024. The default value is
100.
Gateway(config-wlan2)#
control-sideband
[upper|lower]
[upper|lower]
The extra bandwidth will be available when the
channel bandwidth is 40MHz. If you select
Upper
, the extra bandwidth will be extended in
the upper sideband. (
This field is only available
when the network mode is 2.4 GHz (N), 2.4
GHz (G+N), or 2.4 GHz (B+G+N).
)
