CTE PIANOPLAN 600 J SPEEDY STANDARD, Operator'S Maintenance Manual, Page: 31 / 62

Operator’s and Maintenance Manual
Pianoplan 600J Speedy Standard
CODE
504196
31
6.6. Manoeuvre of independent steering
By using the proportional control (Fig.4.2 Pos.1) , it is possible to correct the direction of the
Pianoplan during the climbing or the descent on the stairs: you only have to move the
button on the right or on the left, and the Pianoplan moves in the required direction.
You can also use this operation on large landings. When you manoeuvre to go onto the next
stair it is not necessary to lift the platform and manoeuvre the Pianoplan, but only to push
the above mentioned button and the accelerator during the movement on the floor.
NOTE: we advise you not to make the manoeuvre of independent steering on full
load and on grip surfaces (ex. asphalt, rubber, etc.) because the tracks could detach.
6.7. Manoeuvre on flat surfaces
DANGER: before moving the Pianoplan, check that the route is clear
without obstacles, obstructions or holes and be sure that nobody is
within the working area.
The movement of the Pianoplan on flat surfaces can be done:
- with the Pianoplan controls, moving the proportional manipulator (
Fig. 4.2 Pos. 1 ), moving
the machine ahead, back, on the right and on the left;
- lifting the Pianoplan of some centimetres by moving the control button for the roller lifting
system
(Fig.4.2 Pos.13) and pulling or pushing the Pianoplan along the route. At the
desired point, put down the Pianoplan again using the control button for the roller lifting
system (
Fig. 4.2 Pos. 13 ).
Turning the Pianoplan when it is lifted off the floor on the roller lifting mechanism does the
steering manoeuvre.