Crystal CHP075PX, User Manual

Page: 10 / 51

- 8 -
4.2
Accessories Installation
Anti-vibration bases
1. Take out 4 Anti-vibration
bases
2. Install them on the bottom of
machine.
Note:
Lift the heat pump to install the draining plug. Never
overturn the heat pump, it could damage the compressor.
Draining plug
(NOT winter use
see further info regarding winter
use)
1. Install the draining plug under
the bottom panel
2. Connect with a water pipe to
drain out the water.
Water Inlet & outlet junction
1.Use the pipe tape to connect
the water Inlet & outlet junction
onto the heat pump.
2.Install the two joints like the
picture shows.
3. Screw them onto the water
Inlet & outlet junction.
NOTE: Please check for any shipping moved/damaged pipe work
etc. that is too close to other items that may cause vibration and
rubbing as this would be classed as shipping damage and "NOT"
a warranty issue.
Mains Cable wiring
1. Open the top cover of the
heat pump.
2.Connect the cables in the
correct terminal according to
electric diagram.
3. Please take note of length of
cable runs and possibly
upgraded cable requirement.
NOTE: Any damage caused or PCB`s damaged by doing this
will VOID the warranty.
Filtration pump wiring (Dry
contact)
1. Open the top cover of the
heat pump.
2. Connect the cables in the
correct terminal according to
electric diagram.