Crystal Vision
Card edge operation
SYNNER-E 3G User Manual R1.2
37
10/09/2012
Presets menu
From the STATUS top menu rotate SCROLL/ADJ to select the Presets menu. Press ENTER
and then rotate SCROLL/ADJ to access the presets menu options. To enter a sub menu once
selected press ENTER and use the SCROLL/ADJ control to traverse the sub menu.
Menu
Comment
Factory defaults
Rotate the SCROLL/ADJ. control to show the defaults menu.
Press ENTER to action.
Factory reset
Rotate the SCROLL/ADJ. control to show the factory reset menu.
Press ENTER to action.
Enable GPI
control of presets
Selecting ENABLE allows the recall of previously saved user
configurations via GPI inputs 1-4.
Enable, Disable
Preset location 1
Rotate the SCROLL/ADJ. control to show the preset save menu and
select the chosen location 1-16.
Press ENTER and rotate SCROLL/ADJ. to select SAVE or
RECALL.
Press ENTER to action a save or recall.
Preset location 16
Preset menu and factory reset
Up to 16 user-defined configurations may be stored and recalled either from the board control,
active front panel, Statesman or through the use of external GPIs. Presets store the board setup
data including operating mode card status. The presets are numbered 1-16.
Note:
Care should be taken when storing presets that the desired configuration is not changed by any external
input prior to saving. When pasting a board setup from Statesman, GPI enable will be set to disabled.
Saving and recalling presets
The current board settings can be saved in one of 16 locations to be recalled as desired. This
allows the user to store and recall up to 16 different configurations for later use.
To save the current settings, select the preset location and press ENTER. Select the save
option and press ENTER to write the current settings into this location.
Note:
If the selected location contains previously saved setting information it will be over-
written by the new setting data.
To recall previously stored setting information, again choose the selected location and select
recall, pressing ENTER will recall the stored configuration.
The recalling of previously stored presets can also be implemented externally via the GPI port.
To use this facility, enable GPI control of presets.