Crystal Vision
Card edge operation
SYNNER-E 3G User Manual R1.2
24
10/09/2012
3.4 Reading card edge LEDs
Card edge LEDs may be used in conjunction with status information from any connected
remote status panel display or from Statesman if available.
Refer also to the trouble-shooting chapter for more help with solving problems and
monitoring status information.
The following table summarises the card edge LED functions and colours:
Name
LED
Colour
Function when ON
Function when Off
PSU
Green
Good power supply (PSU) rails
One or more of the monitor
supplies is out of specification
Lock
Yellow
Valid reference input present
HD
Yellow
Video input standard is HD
(High Definition)
Input not present
SD
Yellow
Video input standard is SD (Standard
Definition)
G1
Yellow
Audio Group 1 present
Audio Group 1 not present
G2
Yellow
Audio Group 2 present
Audio Group 2 not present
G3
Yellow
Audio Group 3 present
Audio Group 3 not present
G4
Yellow
Audio Group 4 present
Audio Group 4 not present
nCal
Yellow
Video Gain controls not at cal points
Video Gain control at cal points
GPO6
Yellow
GPO6 active / low
GPO6 inactive / high
3.5 Navigating card edge menus
To access the card edge menu system proceed as follows:
Press the up-arrow [
] until a top menu category is reached
Rotate the SCROLL/ADJ control until the desired menu category is found
Press ENTER to enter the sub menus of that category
Rotate SCROLL/ADJ to select a sub menu
Press ENTER to select the desired function. Selection will be indicated by the
text being displayed in
italic
text
Rotate ADJUST to make the desired change to the selected parameter. The
display brightness flashes slowly to indicate that a change has been made and
requires confirmation
When required push ENTER to action the change. The display will cease
flashing
Use the up-arrow [
] and SCROLL/ADJ control to navigate to further menus
Note:
The displayed menu brightness will flash slowly if confirmation of a change is required.
