ADC104OperationalManualV3_2
Crystal Vision
Page
32
19/09/05
VBI blanking ON/OFF select
Setup ON/OFF select (applies to 525 Standard only)
Betacam chrominance levels ON/OFF select (ADC104F/N)
Test pattern ON/OFF select (ADC104F/FK)
Set Horizontal picture position parameter to factory default values
(ADC104FK)
Set Horizontal picture position and/or Y to UV delay parameters to
factory default values (ADC104F/N)
Remote/local mode select
Shaft encoder adjustment of Horizontal picture position, Y to UV delay
and (ADC104F/FK) test pattern section
Ordering information
ADC104F
10 bit RGBS/YUVS to SDI converter with full 601 specification filtering
ADC104N
10 bit RGBS/YUVS to SDI converter with near 601 specification filtering
ADC104FK
10 bit Y to SDI converter with full 601 specification filtering
FR2AV
2U frame for up to 12 Crystal Vision modules
FR1AV
1U frame for up to 6 Crystal Vision modules
DTB-AV
Desk top box for up to 2 Crystal Vision modules
RM01
Single slot frame rear module. Allows maximum number of ADCs in
frame (12 in 2U, six in 1U, two in desk top box). Gives access to two SDI
outputs
RM02
Four slot frame rear module. One rear module used for three ADCs,
allowing nine ADCs in 2U (fits in 2U frame only). Gives access to three
SDI outputs and syncs loop
RM18
Two slot frame rear module. Allows six ADCs in 2U, three in 1U and one
in desk top box. Gives access to all four SDI outputs and syncs loop
FP1-S, FP1-L, FP2-L,
FP2-LF
Active panels for FR2AV, FR1AV and DTB-AV
REM1U
19” remote control panel
REM1US
Narrow 1U remote control panel
Statesman
PC control system