Crystal Vision
Using the active control panel
18/02/03
Page
13
Selecting time options
The Time menu provides access to the following options:
•
Adjust horizontal position of SDI output picture from 30 pixels to –30 pixels (+/-
2µs)
•
Use syncs on green/luminance or external analogue syncs
•
Luminance/chrominance delay from -111ns to 111ns in 9.25ns steps (not
ADC104FK)
The time menu
Description
Press F1 to toggle between external sync or sync on
Y/G
Press F2 to enable the shaft encoder to control the
horizontal position from 30 to –30 pixels
Press F4 to enable the shaft encoder to control the Y/C
delay from -111ns to 111ns in 9.25ns steps
Note:
The YC Dlay menu is not available with ADC104FK (luminance only) converters.
Selecting control options
The CNTRL menu provides access to the following configuration options:
•
Blank or pass the VBI content of the component input
•
Use YUV or RGB analogue component inputs
•
Normal N10 or Betacam chroma levels (not ADC104FK)
•
Pass or remove 525 line setup or pedestal on luminance
The control menu
Description
Press F1 to toggle VBI blanking On/Off
Press F2 to toggle 525 setup between 0% or +7.5%
Press F3 to select between Y or G input
Press F4 to toggle between normal N10 or Betacam levels
(not ADC104FK)
Notes:
Beta chroma levels are intended for use with 625/525 YUV inputs only
The Chroma level menu is not available with the ADC104FK
The YUV/RGB menu only selects between Y and G with the ADC104FK