27
Switch panel
Starting the fire
Press and hold the power button
continuously until the red light illuminates
next to the
symbol (this takes typically 1 second). As the red
light illuminates release immediately the power button. The red light
will then flash as the burner is being lit. While the burner is lighting
the red light will flash. When the burner has lit the red light will stop
completely. The burner will be at maximum burner rate when first lit.
Note: If the power button is pressed for too long or too short a time
this is taken as an accidental press and the fire will not ignite for
extra safety reasons. It is to try an ensure that the starting
operation of the fire will be most unlikely to be done other than
intentionally by an adult. If not done correctly , wait a few seconds
and try again.
If you wish to power down the fire so it will not start even if any of
the power symbol buttons are pressed, slide the “power Isolating
switch to the “0” position ( perhaps a good idea to do in the event of
leaving the fire not operated for long periods like the summer months
or when going on long holidays).
Red indication light
Press to increase flame
