22
The same thing as above can be done before or during a thermostatic mode
operation (see below).
Thermostatic mode for closed fires
The handset has within it a thermostat sensor and this can be set so the
fire will heat the room to match he temperature set in the handset.
There are 3 temperature types that can be set:-
-Day mode temperature that has a sun symbol on the display – the default
temperature is 24 C
- Night temperature that has a half moon symbol on the display- the default
temperature setting is 18 C
-frost protection that has a snowflake symbol on the display – the default
temperature setting is 5 C
Hold handset and press and release the mode button several times as
necessary until the display has a thermometer symbol flashing at the top of
the display. Press the set button to enter this mode.
Press the set button again to see the temperature setting that is set and
the mode (the default is 24 C ) and on the left of the display is a sun
symbol showing it’s the day temperature.
If a different set temperature is required, while the display is showing this
set temperature , press the + and – buttons to alter the setting. When
finished either press set or leave and after a few seconds the new setting
will be accepted and the display will return to the time of day screen.
On the anniversary of the net minute of the clock, the set temperature will
be compared to the actual temperature displayed on the handset(i.e. the
room ambient temperature around the handset). If the room temperature is
higher than the set temperature the fire will not light until the room has
cooled to below the set temperature. The fire would then automatically turn
itself on when the room is cooler than the set temperature and down and
off if necessary when it is hotter than the set temperature.
