28
Burner regulation
When the burner is in operation, press and release the + and –
buttons to regulate the flame of the burner. Pressing and releasing
the button will move the burner one step at a time. Pressing the
button continuously will move the burner rate to the maximum full
when pr or minimum burner power if pressing -.
Stopping the burner
Press and then release the power button once. The burner will stop
and the red indicator light will illuminate momentarily to show the fire
is turning off.
INSTRUCT THE USER
10.0
Instruct the user on the safe operation of the appliance.
Demonstrate how to operate the Remote Control System.
Explain the function of the ODS as described earlier.
Any cleaning procedures should only be undertaken with the appliance cold.
Show the Customer how to gain access to the Glass Door for cleaning on the Outside and how to gain access
to the Inside for cleaning.
Advise the customer that the fire must never be used with the Door Open or if the Glass Panel is found to be
cracked Chipped or damaged.
Hand all the Instructions to the user for safekeeping and future reference.
Advise the Customer that the Batteries in the Remote Control Hand Set and Receiver must be replaced When
the appliance is serviced
Advise the customer that the flue and fire should be serviced Annually for continued safe operation
Certain wall coverings like blown vinyl should not be used on the wall above the fire
MAINTENANCE
11.0
11:1
To change the batteries it is recommended this is
performed during annual servicing
If required before the glass panel must be removed by
removing the outer frame unscrewing the 4 screws
Remove the glass & remove the fuel pieces and stone
chippings keeping them safe
Remove the 6 screws holding the fire tray cover the tesc
will be seen as photograph top left ,remove the plastic
cover to access the batteries ,replace like for like then
replace cover and fuel following instructions .
