9
How to Arm the System when Staying Home
•
Arming the System in Stay Mode
This type of arming is used when people are present within the protected area. At
nighttime, when the family is about to retire, perimeter zones are protected, but not the
interior zones. Consequently, interior movements will be ignored by the system.
To arm Stay mode press
<STAY>
,
enter user code,
and then <
ENTER
>.
The
A
, B or
C
indicator flashes to indicate that the system is armed in stay mode.
•
Quick Stay
When enabled by the installer, press <
STAY
> to arm the system.
During exit delay you can leave the premises. If you wish to stay or that no one will
enter the protected premises, you may cancel the Entry/exit delay by pressing the
<
ENTER
> key. The slow beeping stops and the system is immediately armed.
The
A, B
or
C
indicator flashes to indicate that the system is armed in stay mode.
(The indicators may go out a few seconds after exit delay expired, depending on the
installer's setting).
•
Disarming the System
Enter
user’s code
and press <
ENTER
>, or press <
STAY
> if enabled by installer.
The
A, B or C
indicator goes off to indicate that the system is disarmed.
How to Arm Partitions
The protected area can be grouped into 3 separate partitions (
A, B, C
). The system can
be grouped for User ‘s convenience to separate, in a business environment, the offices
from the warehouse area, or in a private residence, the different areas in the home, e.g.,
separate downstairs living area, detached garage, etc.
To arm partition A enter user code for partition A
To arm partition B enter user code for partition B
To arm partition C enter user code for partition C
Note
: to arming partition with code see page 8 “How to arm the system before exit”
During exit delay you can leave premises. At the end of the procedure the
A,B
or
C
indicator lights up to indicate that the partition A or/and B or C is armed .
(The indicators may go out after a few seconds, depending on the installer's setting).
To disarm partition, see "Disarming the System".
