15
How to Change or Add Codes
About Master code and User code
The factory default master code (123) is intended as a preliminary control of the alarm
system. After PowerWave is installed and put into service, the code can be changed to
any code known to the Master user. The Master user can define up to 49 user codes. To
limit access rights, the holder of the Master code can ask the installer to define several
User profiles.
Access rights are listed below:
-
User code has Area A and/or B or C access
-
User code can arm and/or disarm arm an area
-
User code can arm and/or disarm arm an area in Stay mode
-
User code can change its code
-
User code can change user’s code
-
User code can Operate control Functions
-
User code can change dialler telephone numbers
-
User code can alter the real time clock
-
User can answer an incoming call and start up/down load
-
User can allow access to installer program mode from client mode.
-
Initiate Walk-test mode.
How to Change Master Code
While in
CLIENT
mode, Press <
PROGRAM
> and
1
to change Master code press
<ENTER>, the code digit will be flashed back to you. Use the numeric keyboard to enter
your new Master code. The code can hold any combination of
1 to 6
digits. It is
recommended using a multi-digit code. . Press <
ENTER
> to save your new code, the
new code will be flashed to you and 3 short beeps to indicate correct entry or 1 long
beep if not accepted. Press <
PROG
> and <
ENTER
> exit user Code Program mode.
How to Add or Change User Code
While in
CLIENT
mode, press <
PROGRAM
> and the
User number
(
2 to 50
) to add or
change the code, press <
ENTER
>. If there is an existing code already, it will be flashed
back to you. Use the numeric keyboard to enter the new code. The code can hold any
combination of
1 to 6
digits. Entering the new code will delete the old code. Press
<
ENTER
> to
save
your new code, the new code will be flashed to you and 3 short
beeps.
Repeat the procedure for all users .
Press <
PROG
> and <
ENTER
> to exit Local Program mode.
