17
How to operate the access control output
If the alarm system has been set up to allow control of an electric door lock, you can
activate the door release function as follows;
Press
<CONTROL>
or Press
<CONTROL> enter CODE then <ENTER>
The Control LED will lights up while the lock is active and turn off as soon as power is
removed from the lock.
The Access Control function can either be a single button operation or restricted to
requiring a valid User code entry. Both options are shown above. Please consult your
installer as to what option may be programmed.
How to start Walk test Mode
While in
CLIENT
mode a User with the proper authority can start walk-test mode. This
special mode latches the alarm signals from detectors at the keypad initiating the test so
that one person can trigger every detector connected to the alarm then return to the
keypad to verify operation. On terminating Walk-test mode the test results are put into
the memory buffer
so they can be viewed at a later time.
To start Walk-test mode while in
CLIENT
mode press
<PROGRAM> <836> <ENTER>
The keypad buzzer will beep at 1-second intervals
Next trigger every detector connected to the panel then return to the keypad and all of
the zones that were triggered will be displayed at the keypad.
To terminate Walk-test mode press
<ENTER>
The keypad will stop beeping and automatically exit
CLIENT
mode.
How to Answer an in-coming call
From time to time your installer may need to access the alarm from a remote PC to
make changes to your programming and for security reasons they may have configured
the alarm so that an authorized person on-site is required to make the alarm system
answer the in-coming call. This option is only available in
CLIENT
mode.
To answer an In-coming Call press
<PROGRAM> <835> <ENTER>
Provided the line connected to the alarm was ringing at the time the panel will now
answer the call and allow a remote PC connection.
