Crow CS-47 GSM, User Manual

Page: 9 / 20

9
3.3.2 Defining SMS Messages for Inputs
The Mobile Bridge allows the definition of different SMS messages to be
sent,
depending on the state of the input. For this reason,the Message area of
the Input
window contains two Message fields.These fields correspond to the two
possible states of an input, which are as follows:
•
On –The input device is running (the input has changed from
“high” to “low”)
•
Off –The input device is not running (the input has changed
from “low” to “high”)
To define the SMS messages to be sent for each input state, perform the
following steps:
1.Click the Input tab.
2.In the Messages area, select the Enable checkbox for each state for
which a message is to be enabled.
3.In the Message field corresponding to the enabled state, enter the SMS
message to be sent.
Note : The Chars Left field displays the permitted number of characters
remaining for each message. This is a read-only field.
4.Define the Detect time (in seconds) for the message. The Detect time is
the amount of time an event must continue in order to trigger the SMS.
5.Define the Delay time (in seconds) for the message. The Delay time is
the amount of time it takes to trigger the SMS after an event has occurred.
6.Define the Repeat time (in minutes) for the message. The Repeat time is
the interval at which the SMS is re-sent, if the status of the input does not
change.
7. In case you need an output to be activated on an input triggering choose
an output number (one of the outputs).