18
4
Using the CS47 after it was installed
4.1 Sending SMS Messages
With the CS47, it is possible to send SMS messages to four different output
devices, to turn the devices on or off.
Note:
It is only possible to send messages if the system has been so configured.
Compose SMS messages to be sent to the Mobile Bridge according to the
following guidelines:
§
Messages can be sent from any ordinary mobile phone.
§
Password – the system is case-sensitive; enter the password accordingly.
§
Messages are sent to the mobile phone number of the relevant unit
§
The System switches from the landline to the cellular phone only after the fourth
digit (including the phone prefix) has been entered. The System must recognize
the phone prefix dialed, or it will not switch to the cellular phone.
§
Mobile programming period
•
If a voice call comes in during this period, the system does not respond. Since it
has switched to data mode, it will only respond to a data call.
•
During this period, the System waits one minute for the data call to be received. If
no data call is received in this time period, the System reverts to voice mode.
•
After the mobile programming period is finished, the Mobile Bridge returns to
Bridge mode.
§
Pulse configuration – if the pulse option was defined during System configuration,
then SMS messages will trigger System outputs accordingly.
4.2 Output operation by SMS
For messages regarding the various outputs, the message must consist of
the following:
User password –must be four characters (lower-case only)
Output number –the number of the relevant output (1-4),as defined during
System configuration (refer to “Configuring System Outputs” ).
Relevant option
n –turn the system on (lower-case only)
f –turn the system off (lower-case only)
The message may not have any spaces:
(User password)(Output number)(Option)
Summary of Contents for CS-47 GSM
Page 20: ...20...
