crosscontrol CCpilot XL, Sub User Manual And Reference Handbook

Page: 15 / 33

User Manual and Reference Handbook for the CC Pilot™ XL
The DMI cable handles display and control signals between the CC Pilot™ XL Display and
PC-unit. The maximum recommended DMI cable length is 5.5 m.
Outer cable shield and LCDS double-shield is connected to the connector cover.
For information concerning the DMI connector on the display see chapter DMI -
Display.
DMI - Display
Marking: DMI
Connector Type: Lemo, female.
Pin Signal Description Comments
1 TXOUT0- LVDS
2 LVDS
3 TXOUT1- LVDS
4 LVDS
5 TXOUT2- LVDS
6 LVDS
7 TXCLK- LVDS
8 TXCLK+ LVDS
9 DMI power
l
+24 V
10 TFT_ON TFT power control
11 Beeper Simple sound unit
12 TS_Tx Touch screen Tx
13 TS_Rx Touch screen Rx
14 SPI_MISO SPI data Display-PC
15 RESET AVR Reset input to AVR Low in, while programming AVR. No
connection in the cable
16 SPI_MOSI SPI data Display-PC
17 SPI_CLK SPI clock Display-PC
18 ON_OFF_2 On/off button from
display to the PC Not implemented
19 GND Ground reference
20 VGA R VGA Red
21 VGA G VGA Green
22 VGA B VGA Blue
23 H Sync Horizontal Sync
24 V Sync Vertical Sync
25 VGA enable Put to gnd when enabled
26 GND VGA Ground reference
The DMI cable handles display and control signals between the CC Pilot™ XL Display and
PC-unit. The maximum recommended DMI cable length is 5.5 m.
Outer cable shield and LCDS double-shield is connected to the connector cover.
For information concerning the DMI connector on the PC unit see chapter DMI - PC.
15