User Manual and Reference Handbook for the CC Pilot™ XL
Power Supply Connector
Marking: POWER IN
Connector Type: Serial 723 8 Pin, male
Pin Signal
Description
Comments
1 NC
Not
connected
2
Don
PC on
10-36 V = PC on
3 Dpow
Unswitched
4
Preheating
Signal to starts preheating of HD
5
Don
PC on
10-36 V = PC on
6 GND
Ground
7 Dpow
Unswitched
8 GND
Ground
The CC Pilot™ XL is primary designed for 24 voltage systems but the power supply
can range from 10 – 36 volts. If the power supply voltage goes beyond this range, the
unit shuts down.
For complete hook up instructions, see the section entitled Installation.
USB (USB 1, USB 2, USB 3, USB 4)
Marking: USB 1, USB 2, USB 3 and USB 4
Connector Type: DIN M12, 5-pole, A-coded, male
Pin Signal
Description
Comments
1 Vbus
Power to external
USB-unit
5 Volt, max 2A for USB 1 and max 500 mA
for USB 2-4. Internal over current and
shortcut protected.
2 D-
Data
3 D+
Data
4 NC
Not
connected
5 GND
Ground
reference
Via the USB port, you can connect a multitude of devices to the CC Pilot™ XL. For
some devices, drivers compatible with the operating system are required to be installed
in order for the device to function.
11
