background image

 

OPERATION 

 

PRE-WARNING SHOCK PROTECTION 

If a low-level shock to the vehicle body is detected, the pre-warning sensor activates sounding 6 quick siren chirps and 
1 light flash.  Adjust the shock sensor as needed by turning the control knob clockwise to increase sensitivity and 
counter-clockwise to decrease sensitivity.  To bypass sensor, press Button #3 (Trunk) within 2 Sec. of arming. 

 

EMERGENCY OVERRIDE/DISARM 

If you have lost the transmitter or it stops working for any reason and the Alarm is armed, you will have to open the 
door with the key, which will activate the alarm.  Turn the ignition on and press the override/program button about 2 
seconds.  The Alarm will disarm and enter the Valet mode which allows you to use the vehicle until you can 
repair/replace the remote transmitter at which time you can take the vehicle out of valet. 

 

VALET MODE 

To disable the Alarm system while still allowing door lock/unlock and AUX feature, turn the ignition on and press the 
override/program button until the dash LED turns on solid (about 4 seconds) and you hear (1) siren chirp.  Repeat the 
process to exit VALET mode and the system will chirp (2) times and the LED will turn off. 

 

SILENT ARM/DISARM MODES: 

• 

THROUGH THE TRANSMITTER 

This system can be armed and disarmed without chirps as needed.  Press and Quickly release Button #3 (Trunk pop) 
to Arm and Disarm system without chirps.  Note: If Button #3 is pressed too long, then the Aux. 1 will activate! 

 

• 

SILENT ARMING /DISARMING (THROUGH PROGRAMMING) 

The system can be silently armed and disarmed as normal with Lock/Unlock Buttons but no siren chirp.  See alarm 
programming option (6) to enable or disable this feature. 

 

PASSIVE ARMING / PASSIVE LOCK MODES 

Both modes must be set ON or OFF prior to install.  Consult your authorized dealer. 
Passive (Automatic) Arming will occur 30 Seconds after the ignition is turned off and the last door has been closed.  
The LED will begin flashing rapidly while counting down.  If a door is reopened, the system will wait (LED solid) for the 
door or zone to close before arming and bypassing it.  After 30 seconds or when all entry points close, the unit will arm 
(1 chirp/1 light flash) and Doors will lock if passive locking is selected. 

 

PRIOR INTRUSION ALERT 

If the system was tripped in your absence, the dash LED will be flashing rapidly.  When the system is disarmed you will 
hear 3 chirps (and 3 light flashes).  Carefully inspect your vehicle to see if there is any damage or a theft has occurred. 

 

DOME LIGHT ILLUMINATION (OPTIONAL) 

This feature turns on the vehicles dome light upon disarm for 30 seconds or until the key is inserted and turned on.  
This will provide illuminated entry to your vehicle at night or in dimly lit areas for safety and security.

 

10 

Summary of Contents for Gargoyle CS-2001













Reviews: