3
CONTROL MODULE/COMPONENT MOUNTING
CONTROL MODULE:
The alarm control module should be mounted in a concealed location. DO NOT mount the control unit
in the engine compartment. Fasten the module to a bracket or wire harness using the cable ties provided.
ANTENNA MODULE:
For
optimum range and performance, the antenna/receiver module should be located high up on the
front windshield glass. For example: behind the rearview mirror. Note: Window tint or films may decrease the range of the
system. The mounting surface for the antenna should be clean and dry.
SIREN MOUNTING:
Mount the siren under the hood to fender-well or other body surface with the open end facing
downward. Run the red siren wire through the firewall using a rubber grommet. Ground the black wire to the body.
LED:
Mount the LED in a visible location on the dashboard or console.
SHOCK SENSOR:
Mount the included shock sensor with wire ties to an under dash wire harness or fasten with screws to
firewall or side paneling.
OVERIDE/PROGRAM BUTTON:
Mount the Override/Program push-button in a hidden but accessible location. It is used for
emergency disarm without the use of the transmitter and for programming certain features.
(H1) 6-PIN WHITE CONNECTOR
RED WIRE: +12V POWER INPUT (3 Amp Fuse)
Connect to a +12Volt source with the supplied fuse and fuse-holder. We recommend the connection to be at the Vehicle’s
Battery Positive Terminal.
BROWN WIRE: (+) SIREN OUTPUT (3 Amp Max.)
Connect to the siren’s RED wire. Connect the Siren’s Black Ground wire to the chassis close to the siren.
BLACK WIRE: CHASSIS GROUND
THIS WIRE NUST BE CONNECTED TO THE CHASSIS METAL OF THE VEHICLE. Scrape away any paint or dirt to ensure
a good connection.
WHITE WIRE: +12V FLASHING PARKING LIGHT OUTPUT (optional)
Connect to switched parking light wire at back of light switch or connect directly to one of the parking lights at the front of the
vehicle. European vehicles may require additional parts due to separate left and right circuits.