WIRING - MINI PLUGS
2 PIN (WHITE) PLUG:
RED/BLACK WIRE: DOME LIGHT ILLUMINATION (Optional, Requires Relay)
Connect to terminal 85 of relay. This wire turns the dome light on for 30 seconds upon disarming of the alarm. If the
ignition is turned on or the alarm is re-armed, the dome light will turn off again. Connect this wire to terminal 85 of a
relay. Connect terminal 86 to +12V Constant. Connect terminal 87 to +12V or ground depending on the type of Dome
Light/Door Pin circuit that is in the vehicle. See Page 19.
WHITE/YELLOW: HORN HONK OUTPUT (Optional, Requires Relay)
Negative pulsed output for honking the vehicle's horn when the alarm is triggered. Connect this wire to terminal 85 of a
relay. Connect terminal 86 to +12V Constant. Connect terminal 87 to +12V or ground depending on the type of horn
activation circuit in the vehicle. Connect terminal 30 to the horn activation circuit.
2 PIN (BLUE) PLUG: PROGRAM / OVERRIDE BUTTON
2 PIN (RED) PLUG: LED INDICATOR
(Red Flashing Light)
3 PIN (RED) PLUG:
GREEN/BLACK: (-) AUX. REMOTE OUTPUT (Optional, Requires Relay)
Connect to terminal 85 of relay. Connect terminal 86 to constant. Connect terminal 87 to +12V or Ground depending
on the type of circuit that needs to activated. Connect terminal 30 to the device/circuit to be activated.
RED: (-) OEM FACTORY DISARM OUTPUT
Provides a ground pulse to disarm the vehicles' FACTORY anti-theft system prior to Remote Start. Connect this wire to
the vehicles' anti-theft disarm wire. This wire may be found coming off the Driver's door key switch or the Factory Anti-
theft control module. This wire may not be needed if Factory Security only requires a door unlock pulse.
YELLOW: VACUUM SWITCH INPUT (Used with a Vacuum switch for Engine Monitor only)
3 PIN (WHITE) PLUG:
GREEN
: (-) NEGATIVE LOCK Connect directly to negative lock/unlock systems. If vehicle uses
RED:
+12V For Relays positive door lock signals or reversing polarity type, then external
BLUE:
(-) NEGATIVE UNLOCK relays must be added. See Power Door Lock Wiring.
4 PIN (WHITE) SENSOR PLUG:
WHITE:
NEGATIVE PRE-WARN The sensor supplied with the system does not require
BLACK
: SENSOR GROUND any additional wiring. Simply mount sensor in a suitable
BLUE:
NEGATIVE TRIGGER location, plug in, and adjust sensitivity.
RED:
SENSOR POWER
